For Comfort And Energy Savings Consider Rigid Foam Board InsulationFoam board insulations are generally used in curtain walls, roofs, foundations, entry and overhead garage doors, pipes as well as tanks. The foam board insulation does not only insulate, but also offer soundproofing to some extent. However, concrete or masonry walls require rigid foam board insulation. The rigid foam board insulation can also be placed in a cast-in-place wall and interlocking rigid foam blocks can be used as permanent forms for concrete foundations. The foam board insulations are generally placed between the bricks and the studs in the exterior walls. In order to prevent the infiltration of moisture and air in the walls the rigid insulation boards are placed tightly together and the closure is sealed with a tape or a caulking. This kind of insulation, though, is not always preferred because termites and other pests can easily use it as a tunnel or a protective cover. This can reduce the R-value and structural integrity of the insulation. Thus, manufacturers prefer to treat their products with insecticides before releasing them in the market. At times, ignition of these foam boards also release deadly poisonous gases, therefore, it is important to provide an adequate fire barrier to these insulations. The foam insulation also requires complete protection from direct sunlight. The harmful ultraviolet rays can cause severe damage to them over time. All these factors combined, affect the prices of these products, which are completely determined based on their qualities. These different kinds of insulation are used not only for residential purpose but are equally important in industrial use as well. Industrial applications generally require pipe insulation, board insulation, blanket insulation, spray foam insulation and many others. Whether commercial or industrial, there are a few insulations that are used in all kinds of constructions. Below the first floor of all buildings, there is an unfinished accessible area called the crawl space. These crawl spaces are of two types: vented and unvented. The vented crawl space opens to the outside and requires insulation of the underfloor. The unvented crawl space is a part of the basement and necessitates insulation of the perimeter walls. It is to be made sure that a tight-sealing ground-moisture barrier is installed before insulating the crawl space. For any of these insulations it is suggested to approach a company that is a major distributor of commercial and industrial insulations. Such companies provide high quality products and superior services to the entire customer base. They supply all kinds of insulation products ranging from blankets and wraps to rolls and batts. Blanket insulation typically uses fiber glass, mineral wool and cotton. Loose-fill insulations however, require blowers for their installation. The loose-fill insulations use cellulose as the material helps to insulate the attics and walls. Before using the insulation blower, it is advised to have a complete understanding of its usage and the parts needed for its use. |